Reverse Or Motion Alarm (Optional); Park Brake - Taylor-Dunn B0-050-00 Operation, T Roubleshooting And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS

Reverse or Motion Alarm (Optional)

The reverse alarm is located in the electronics compartment mounted in the speed control panel enclosure.
The reverse alarm is activated when the Key switch is in the "ON" position and the Forward-Off-Reverse
switch is in the reverse position. The alarm makes a repeated audible sound.
The motion alarm is the same alarm that is used for the reverse alarm, only it operates in both the
forward and reverse directions.

Park Brake

The parking brake is part of the foot brake pedal. To set the parking
brake, push down on the lower half of the brake pedal until the pedal
locks in the down position. To release the park brake, apply pressure
on the upper half of the brake pedal until the pedal disengages from
the locked position.
Electrolyte Alarm (Optional)
The Electrolyte Alarm is located in the battery area, in the 4th battery
cell from the main battery positive cable. The Electrolyte alarm is
activated when the battery cell fluid level falls below the level of the
probe. The alarm is an audible continuous sound along with a bi-color
indicator lamp. Inspect the fluid level in all battery cells when the alarm
sounds or the bi-color lamp turns from its green color to red. The vehicle
batteries should then be filled and/or charged. With the fluid level at a
normal operating level and/or the batteries charged the alarm and light
will reset.
Safety Rules Page 9