Installation; Steering Component Service - Taylor-Dunn B0-050-00 Operation, T Roubleshooting And Replacement Parts Manual

Installation

6. Raise the front of the vehicle and support with jack stands.
7. Install the A-arm in reverse order of removal.
NOTE: Refer to Tires and Wheels section for information regarding
NOTE: Refer to
8. Realign the front wheels. Refer to
regarding realigning the front wheels.
9. Lower the vehicle.
10. Reconnect the main positive and negative cables at the batteries.
11. Remove the blocks from behind the wheels.
12. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
removing the front wheels.
Replace King Pins and Bushings
information regarding installing the king pin.

Steering Component Service

Front Axle
R
Page 5
section for
section for information