Change Oil - Taylor-Dunn B0-050-00 Operation, T Roubleshooting And Replacement Parts Manual

CHANGE OIL

Park the vehicle on a level surface.
6. Place a drain pan that can hold a minimum of
2-quarts of oil under the transmission.
7. Remove the level plug then lift the side of the vehicle
without the level plug and allow the oil to drain out.
8. Lower the vehicle and now lift the side of the vehicle with the level plug and add 11-ounces of oil
(see illustration on preceding page).
9. Lower the vehicle, allow any excess oil to drain into the drain pan, and then reinstall the level
plug.
10. Reconnect the main positive and negative cables at the batteries.
11. Remove blocks from behind the wheels.
12. Test drive the vehicle
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap,
hoist, and jack stands, of
adequate capacity to lift and
support the vehicle. Failure
to use lifting and support
devices of rated load capacity
may result in severe bodily
injury.
Transmission
Level Plug viewed from in front of
the right rear wheel
Page 3