Taylor-Dunn B0-050-00 Operation, T Roubleshooting And Replacement Parts Manual page 99

REPLACE THE FRONT SPRING
6. Raise the front of the vehicle and support with jack stands.
7. Tie up or support the left and right side front wheel so they cannot pivot down.
8. Remove the two u-bolts holding the spring to the center frame member.
9. Slide the spring out from under the A-arm spring bushings.
10. It is recommended that the A-arm spring bushings be replaced any time the spring is replaced.
11. Install the new spring in reverse order.
12. Lower the vehicle.
13. Reconnect the main positive and negative cables at the batteries.
14. Remove the blocks from behind the wheels.
15. Release the parking brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove the
key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Suspension Page 3