Transmission; Removal And Installation - Taylor-Dunn B0-050-00 Operation, T Roubleshooting And Replacement Parts Manual

TRANSMISSION

Removal and Installation

6. Remove the rear deck access plate.
7. Disconnect the motor wires from the motor.
8. Remove the clevis pins from the brake cables (right
side shown).
9. Support the rear of the vehicle with a lifting device
but do not raise the rear wheels off of the ground.
10. Remove the lower shock bolts and compress the
shocks to get them out of the way..
11. Lift the rear of the vehicle just high enough to remove
the coil springs and place the frame of the vehicle
on jack stands
12. Remove the springs and spring mounting plates
from the axle tubes.
13. Remove the bolts holding the swing arm to the axle
tubes and roll the transmission out from the vehicle.
14. Install in reverse order.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove the
key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Transmission Page 9