Key Counter Installation - Ricoh A172 Service Manual

2.6 KEY COUNTER INSTALLATION

[C]
[F]
1. Remove the following parts. (Refer to Exterior And Inner Covers.)
•
Upper rear cover
•
Right inner cover
•
Upper right cover
2. Remove the key counter cover [A] (2 screws) from the key counter holder
bracket [B].
3. Disconnect the short-circuit connector [C] from the key counter connector
[D].
4. Couple the connector [D] with the key counter connector [E].
5. Hold the securing plate [F] on the inside of the key counter holder bracket
and insert the key counter holder [G].
6. Align the screw holes in the securing plate with the mounting holes in the
key counter holder and secure the key counter holder (2 screws).
NOTE: The securing plate has three different hole sizes. Use the holes
that match those on the key counter holder that you are installing.
7. Reinstall all the covers and check the key counter operation.
SM
[D]
[E]
3-31
[B]
[A]
[G]
A172/A199