Key Counter Holder Installation - Ricoh FT2260 Service Manual

1 August 1988

6. KEY COUNTER HOLDER INSTALLATION

NOTE: Three types of counters are recommended for this copier (Ricoh,
Hecon, and Hengstler key counters).
Remove the upper right cover (4 screws), upper rear cover (2 screws),
1.
and the optics board (2 screws, 7 connectors).
2.
Remove the key counter cover [A] and fixing plate [B] from the key
counter bracket (2 screws).
3. Hold the fixing plate on the inside of the key counter bracket and insert
the key holder [C].
4. Align the holes in the fixing plate with the mounting holes of the key
counter holder and secure the key counter holder.
NOTE: The fixing plate has three sets of holes. Make sure to use the holes
that match the type of counter when installing.
5. Remove the shorting plug [D] from the key counter connector [E].
Plug in the key counter harness.
6.
7. Reassemble the copier. Insert the key counter and check its operation.
3-12