Ricoh A172 Service Manual page 147

8. Route the harness above the left rail of the 1st tray [A] from the left side
to the rear.
9. Place the controller interface harness bracket [B] on the left side frame
and secure it with the grounding wire (1 screw) [C].
10. Remove the timing belt [D] and install the two harness clamps [E].
11. Route the harness from the lower to the upper as shown [F].
NOTE: Route the harness behind the charge inlet fan duct.
A172/A199
[A]
[C]
[B]
[D]
3-56
[F]
[E]
SM