Table of Contents
Advertisement
Rev. 1/16/97
6 . Open [2]SP Test, page 2.
7 . Select " Full Dot Pattern " [A] in Pattern selection and select " Set " [B] in
Test Pattern Condition.
8 . Touch the "Copy in SP" key and select " Black " copy mode.
9 . Touch the "SP MODES" key and open [2]SP Test, page 5.
10 . Start the Printer Free Run by touching " ON " [C] and wait for 6 to 7
minutes.
11 . Stop the Printer Free Run by touching " OFF " [D].
12 . Open [2]SP Test, page 2 and select " Reset " [E] for Test Pattern
Condition.
13. Wait for 5 minutes and open [2]SP Test, page 4.
14. Perform Process Control Selfcheck by touching " Start ".
15. Check the result of Process Control Selfcheck referring to the installation
procedure and exit the SP mode.
16. Perform Auto Color Calibration.
A172/A199
[E]
[B]
[A]
[C]
[D]
5-12
SM
Advertisement
Table of Contents
