Table of Contents
Advertisement
50. Install the cyan, magenta and yellow developer in the same manner as
black developer installation (step #40 to #49).
NOTE: To select the "color development drive motor ON" mode, enter
"69" for color instead of 68 for black (refer to step #45).
51. Return the developer supply funnel to the original position.
52. Touch the Previous key [A] to open page 3.
53. Perform developer initial setting as follows.
1) Confirm that the main charge corona, PCC, ID sensor boards are set
correctly (1 screw each).
2) Confirm that the toner tank is not installed.
NOTE: If the toner tank is installed, toner is supplied during developer
initial setting and the machine cannot figure out the proper toner
concentration of the new developer.
3) Touch the All Start key [B] to start the developer initial setting. After the
adjustment is completed, the machine stops automatically.
54. Touch the Index key [C].
SM
[B]
3-19
[A]
[C]
A172/A199
Advertisement
Table of Contents
