Figure 4-5 Drive Cable Clearances - Emerson Digitax ST User Manual

Safety Product Mechanical
Information information installation
4.10.3 Recommended cable management

Figure 4-5 Drive cable clearances

The external EMC filter can be
bookcase mounted (next to the
drive) or footprint mounted (with
the drive mounted onto the filter).
External
controller
Signal cables
Plan for all signal cables
to be routed at least
300mm (12in) from the
drive and any power cable
28
Electrical Getting Basic
installation started parameters
Thermal
overload
protection
device
Metal back
plate
www.controltechniques.com
Running the SMARTCARD
Optimization
motor Operation
Optional
braking resistor
Locate optional braking
resistor and overload
external to cubicle
(preferably near to or
on top of the cubicle).
Onboard Advanced Technical
PLC parameters Data
Note
For EMC compliance:
1) When using an external EMC
filter, one filter is required for
each drive
2) Ensure direct metal contact
at drive and filter mounting
points (any paint must be
removed)
AC supply
contactor and
fuses or MCB
Digitax ST User Guide
UL listing
Diagnostics
information
Issue: 3