Emerson Digitax ST User Manual page 190

Safety Product Mechanical
Information information installation
Trip
SLX.Er Solutions Module slot X trip: Solutions Module in slot X or Digitax ST Plus/Indexer has detected a fault
Automation (Applications) module category
Check value in Pr 17.50. The following table lists the possible error codes for the Digitax ST Plus and Digitax ST Indexer. See the
Diagnostics section in the SM-Applications Modules and Motion Processors manual for more information.
Error Code
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
202,207,212
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
190
Electrical Getting Basic
installation started parameters
Trip Description
User program stack overflow
Unknown error - please contact supplier
Parameter does not exist
Attempt to write to a read-only parameter
Attempt to read from a write-only parameter
Parameter value out of range
Invalid synchronisation modes
Unused
Synchronisation lost with CTSync Master
RS485 not in user mode
Invalid RS485 configuration
Maths error - divide by zero or overflow
Array index out of range
Control word user trip
DPL program incompatible with target
DPL task overrun
Unused
Invalid timer unit configuration
Function block does not exist
Flash PLC Storage corrupt
Drive rejected application module as Sync master
CTNet hardware failure. Please contact your supplier
CTNet invalid configuration
CTNet invalid baud-rate
CTNet invalid node ID
Digital Output overload
Invalid function block parameter(s)
User heap too large
RAM file does not exist or a non-RAM file id has been specified
The RAM file specified is not associated to an array
Failed to update drive parameter database cache in Flash memory
User program downloaded while drive enabled
Failed to change drive mode
Invalid CTNet buffer operation
Fast parameter initialisation failure
Over-temperature
Hardware unavailable
Module type cannot be resolved. Module is not recognised.
Inter-Solutions Module comms error with module in slot 1
Inter-Solutions Module comms error with module in slot 2
Inter-Solutions Module comms error with module in slot 3
Inter-Solutions Module comms error with module unknown slot
APC internal error
Communications to drive faulty
www.controltechniques.com
Running the SMARTCARD
Optimization
motor Operation
Diagnosis
Onboard Advanced Technical
Diagnostics
PLC parameters Data
Digitax ST User Guide
UL listing
information
Issue: 3