Emerson Digitax ST User Manual page 192

Safety Product Mechanical
Information information installation
Trip
SLX.Er Solutions Module slot X trip: Solutions Module in slot X has detected a fault
Automation (I/O Expansion) module category
Check value in Pr 15/16.50. The following table lists the possible error codes for the SM-I/O Plus, SM-I/O Lite, SM-I/O Timer, SM-I/O
PELV, SM-I/O 120V and SM-I/O 24V Protected. See the Diagnostics section in the relevant Solutions Module User Guide for more
information.
Error code
0
1
202,207,212
2
3
4
5
74
SLX.Er Solutions Module slot X trip: Solutions Module in slot X has detected a fault
Fieldbus module category
Check value in Pr 15/16.50. The following table lists the possible error codes for the Fieldbus modules. See the Diagnostics section
in the relevant Solutions Module User Guide for more information.
Error code
0
52
61
64
65
66
69
202,207,212
70
74
75
76
80
81
82
83
84
85
86
87
98
99
192
Electrical Getting Basic
installation started parameters
Module
All
All
SM-I/O Lite, SM-I/O Timer
SM-I/O PELV, SM-I/O 24V Protected
SM-I/O PELV, SM-I/O 24V Protected
SM-I/O 24V Protected
SM-I/O PELV
SM-I/O Timer
All
Module
All
SM-PROFIBUS-DP-V1, SM-Interbus,
SM-DeviceNet, SM-CANOpen
SM-PROFIBUS-DP-V1, SM-Interbus,
SM-DeviceNet, SM-CANOpen, SM-SERCOS
SM-DeviceNet
SM-PROFIBUS-DP-V1, SM-Interbus,
SM-DeviceNet, SM-CANOpen, SM-SERCOS
SM-PROFIBUS-DP-V1
SM-CAN, SM-DeviceNet, SM-CANOpen
SM-CAN
All (except SM-Ethernet)
SM-Ethernet
All
SM-Ethernet
SM-Ethernet
All (except SM-SERCOS)
All (except SM-SERCOS)
All (except SM-SERCOS)
All (except SM-SERCOS)
SM-Ethernet
SM-Ethernet
SM-Ethernet
SM-Ethernet
All
All
www.controltechniques.com
Running the SMARTCARD
Optimization
motor Operation
Diagnosis
No errors
Digital output overload
Analog input 1 current input too high (>22mA) or too low (<3mA)
Digital input overload
Analog input 1 current input too low (<3mA)
Communications error
User power supply absent
Real time clock communication error
Module over temperature
No trip
User control word trip
Configuration error
Expected packet rate timeout
Network loss
Critical link failure
Bus off error
No acknowledgement
Flash transfer error
No valid menu data available for the module from the drive
Solutions module over temperature
The drive is not responding
The Modbus connection has timed out
Inter-option communications error
Communications error to slot 1
Communications error to slot 2
Communications error to slot 3
Memory allocation error
File system error
Configuration file error
Language file error
Internal watchdog error
Internal software error
Onboard Advanced Technical
Diagnostics
PLC parameters Data
Reason for fault
Trip Description
Digitax ST User Guide
UL listing
information
Issue: 3