Checking The Headlight Setting; Adjusting The Headlight Range; Changing The Speedometer Battery - HUSABERG TE 125 EU Owner's Manual

14 ELECTRICAL SYSTEM
14.9

Checking the headlight setting

14.10

Adjusting the headlight range

14.11

Changing the speedometer battery

Finishing work
–
Check that the turn signal system is functioning properly.
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Turn adjusting screw
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (instructions on how to apply the mark: Checking the
headlight setting).
Info
Turn clockwise to reduce the headlight range; turn counterclockwise to
602529-10
increase the headlight range.
A change in weight on the vehicle may require a correction of the headlight
range.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer upward out of the holder.
L00251-10
under the first mark.
B
B
A
p. 86)
to adjust the headlight range.
1
.
1
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 86)
p. 84)
86