14
ELECTRICAL SYSTEM
14.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
14.2
Installing the battery
14.3
Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
(TE 250/300)
x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Disconnect the negative cable
–
Pull back the positive terminal cover
battery.
–
Detach rubber band
–
Lift the battery up and out.
602525-10
(TE 250/300)
x
Main work
–
Place the battery in the battery holder.
Battery (YTX4L-BS) (
–
Attach rubber band
–
Attach the positive cable and replace the positive terminal cover
Guideline
Screw, battery terminal
Info
Contact disks
sockets
–
Attach negative cable
602526-10
Finishing work
–
Mount the seat. (
(TE 250/300)
x
p. 53)
of the battery.
1
and disconnect the positive cable of the
2
at the bottom.
3
p. 110)
.
1
must be mounted between battery terminals
A
with the claws facing up.
5
.
3
p. 53)
.
2
M5
2.5 Nm
(1.84 lbf ft)
4
82
and cable