System Reset
Use the Reset button beneath the faceplate to return the device to default settings or to
restore factory-shipped firmware (see to the Reset Mode Summary table below for more
details). If necessary, remove the faceplate.
Mode
Mode Activation
1
Hold the Reset button down
while applying power to the
device.
NOTE: After a mode 1
reset, update the device
with the latest firmware
version. DO NOT operate
the firmware version that
results from this mode
reset.
5
Hold the Reset button down
for about 9 seconds or until
the Power LED blinks three
times. Then press the Reset
button momentarily (for
<1 second) within 1 second.
NOTE: The reset
procedure is aborted if
the second momentary
press does not occur
within one second.
Reset Mode Summary
Result
The device reverts to the factory
•
default firmware.
All user files and settings (audio
•
adjustments, audio input selection,
input selection, auto-switch mode,
picture adjustments, and input
video format) are maintained.
Mode 5 performs a complete
•
reset to factory defaults except for
firmware.
Reset all user modifiable
•
configurations to default values
including real-time adjustments.
The Power LED blinks 4 times in
•
quick succession during the reset.
FOX T UWP 302 Wallplate Transmitter • Installation and Operation
Purpose/Notes
Use mode 1 to revert
to factory firmware for
a single power cycle if
an incompatibility issue
arises.
Use mode 5 to start
over with configuration
or uploading.
NOTE: This is
equivalent to SIS
command
.
ZXXX
14