Using The Command And Response Tables For Sis Commands; Symbol Definitions - Extron electronics FOX T UWP 302 User Manual

•
X%
1Lnk 2Lnk
The FOX T UWP 302 returns this status message whenever a change in the fiber link, video,
or audio connection occurs. X% indicates whether the link is present or not present
( = not present,
0
singlemode (
Error responses
When the FOX T UWP 302 receives an SIS command and determines it is valid, it performs
the command and sends the corresponding response to the host device. If the command is
determined invalid or contains invalid parameters, the transmitter returns an error response
to the host. The error response codes are:
= Invalid input number
E01
= Invalid switch attempt in this mode
E06
= Invalid command
E10
= Invalid parameter
E13

Using the Command and Response Tables for SIS Commands

The Command and Response Tables
acceptable in the command field except where indicated. Figure 9 shows the hexadecimal
equivalent of ASCII characters used in the command and response tables.
Space
Figure 9.

Symbol Definitions

]
¦
or
}
•
or W
E
• • •
X% X% X% X1)
Vid Aud
= present) and X1) represents whether the device is multimode or
1
= multimode, = singlemode).
MM SM
ASCII to Hex Conversion Table
ASCII to Hexadecimal Conversion
= Carriage return and line feed
= Carriage return with no line feed
= Space
= Escape key
FOX T UWP 302 Wallplate Transmitter • SIS Configuration and Control
•
]
TX
= Not valid for this configuration
E14
= Invalid command for signal type
E17
= Busy
E22
begin on page 18. Lowercase letters are
•
16