Table of Contents
Advertisement
Installation and
Operation
This section describes procedures to cable, connect, and manually operate the
FOX T UWP 302. Topics in this section include:
•
•
•
•
•
Installation Overview
Install the FOX T UWP 302 into an electrical UL Listed junction box.
CAUTION: Risk of personal injury. Failure to check the items listed below may result
ATTENTION : Risque de blessure. La non-vériication des éléments listés ci-dessous
ATTENTION:
ATTENTION : La non-vériication des éléments listés ci-dessous peut provoquer des
1.
2.
3.
4.
Installation Overview
Rear Panel Features
Front Panel Features
Mounting and Making Connections
Operation
in personal injury.
peut provoquer des blessures.
Failure to check the items listed below may result in property damage.
dommages matériels.
Prepare the mounting surface
Ensure there are no utility cables or pipes at the intended location that might be
•
damaged or cause injury when installing the device.
Check that the installation meets building, electrical, and safety codes.
•
Ensure there is sufficient space behind the device.
•
Choose a location that will allow cable runs without interference.
•
NOTES:
•
Cables may need to be installed in the wall or conduits before installation.
•
For junction boxes, refer to the manufacturer for more installation
requirements.
Cut a hole in the mounting surface.
Install the junction box according to the junction box installation instructions.
Prepare and pull the cables through the junction box.
Secure cables with clamps or ties to provide strain relief.
TIP:
FOX T UWP 302 Wallplate Transmitter • Installation and Operation
5
Advertisement
Table of Contents
