Table of Contents
Advertisement
Operation
After all devices are connected and powered, the system is fully operational. The
FOX T UWP 302 can be configured through SIS commands (see
Control
Program
Initial Power Up
Upon initial power up, all the front panel LEDs blink simultaneously. They blink once to
indicate the device is a multimode device or twice to indicate the device is a singlemode
device. Afterwards, the LEDs return to their normal signal presence indication.
If a different SFP module or no SFP module is connected, the LEDs first blink once or twice
to identify the device and then blink continuously.
System Reset
Use the Reset button beneath the faceplate to return the device to default settings or to
restore factory-shipped firmware (see to the Reset Mode Summary table below for more
details). If necessary, remove the faceplate.
Mode
Mode Activation
1
Hold the Reset button down
while applying power to the
device.
NOTE: After a mode 1
reset, update the device
with the latest firmware
version. DO NOT operate
the firmware version that
results from this mode
reset.
5
Hold the Reset button down
for about 9 seconds or until
the Power LED blinks three
times. Then press the Reset
button momentarily (for
<1 second) within 1 second.
NOTE: The reset
procedure is aborted if the
second momentary press
does not occur within one
second.
on page 13) or the FOX Extenders control program (see
on page 21).
Reset Mode Summary
Result
•
The device reverts to the factory
default firmware.
•
All user files and settings (audio
adjustments, audio input selection,
input selection, auto-switch mode,
picture adjustments, and input
video format) are maintained.
•
Mode 5 performs a complete
reset to factory defaults except for
firmware.
•
Reset all user modifiable
configurations to default values
including real-time adjustments.
•
The Power LED blinks 4 times in
quick succession during the reset.
FOX T UWP 302 Wallplate Transmitter • Installation and Operation
Simple Instruction Set
FOX Extenders Control
Purpose/Notes
Use mode 1 to revert
to factory firmware for
a single power cycle if
an incompatibility issue
arises.
Use mode 5 to start
over with configuration
or uploading.
NOTE: This is
equivalent to SIS
command
.
ZXXX
12
Advertisement
Table of Contents
