Table of Contents
Advertisement
•
•
•
Reset Modes
The rear panel Reset button initiates three levels of resets (numbered 1, 4, and 5). Use a
pointed stylus, ballpoint pen, or small screwdriver to access the recessed button.
See the
ATTENTION:
HDMI Format — After selecting HDMI Format press the or buttons to select the
output format. The format choices include:
Auto (based on the EDID of the sink) (default)
•
•
DVI RGB 444 (no audio, no Infoframe)
•
HDMI RGB 444 Full
HDMI RGB 444 Limited
•
•
HDMI YUV 444 Full
HDMI YUV 444 Limited
•
•
HDMI YUV 422 Full
•
HDMI YUV 422 Limited
Test Pattern — Press the navigation buttons to select an available test pattern to
display or to turn a test pattern off. The available test pattern selections are Crop,
Alternating Pixels, Crosshatch, Color Bars, and Grayscale 32 Level. The
default setting is Off.
Figure 13.
Test Patterns
Factory Reset — Resets the unit to its factory default values (removing any user-
specified values) while retaining all TCP/IP settings.
To reset using the OSD menu, press and hold the Enter button until Factory Reset is
displayed (approximately 5 seconds). The message remains for approximately 1 minute
after the reset is complete to allow time for the display device to sync with the FOX3
output.
Reset Modes
table and
•
Review the reset modes carefully. Some reset modes delete all user loaded content
and revert the device to default configuration.
Analysez minutieusement les différents modes de réinitialisation. Certains modes de
•
réinitialisation suppriment l'intégralité du contenu chargé de l'utilisateur et remettent
l'appareil au mode de configuration par défaut.
figure 14
on page 17 for a summary of the resets.
FOX3 SR 201 Scaling Receiver • Operation
16
Advertisement
Table of Contents
