Table of Contents
Advertisement
Connect
The
option establishes communication with a disconnected device. A
Connect
disconnected device may include a device that has timed out after prolonged inactivity or
a new device that has yet to be connected. If a device is already connected, the Connect
option is disabled until the device is disconnected or the connection times out.
To establish a connection:
1.
From the
menu, select
File
bar. This displays the
Communication Setup
page 24).
2.
Select the desired connection method.
To connect the software to the device through the rear panel Remote RS-232
•
connector, click the
drop-down list (see the left side of figure 10).
To connect the software to the device through the front panel USB connector, click
•
the
tab and select the Extron USB device from the
USB
drop-down list (see figure 8, right).
3.
Click the
button. The FOX Extenders Control Program window appears.
Connect
NOTE: Some controls and displays are available only when connected to speciic
devices.
Disconnect
The
option stops communication with the current device, but leaves the FOX
Disconnect
Extenders Control Program open. Once disconnected, configuration can no longer be done
unless connection is re-established.
To disconnect from the device, select
below the menu bar. The status bar at the bottom of the window indicates that the device is
disconnected.
Exit
The
option closes the FOX Extenders Control Program.
Exit
To exit the program, select
Tools Menu
The
menu contains options for displaying device information or configuring the
Tools
device.
Figure 13.
Tools Menu
FOX T UWP 302 Wallplate Transmitter • FOX Extenders Control Program
. Alternatively, click the
Connect
dialog box opens (see
tab and select the desired port from the
RS232
from the
Disconnect
from the
menu.
Exit
File
icon below the menu
figure 10
on
Port
Extron USB Device
menu or click the
File
icon
26
Advertisement
Table of Contents
