Table of Contents
Advertisement
Pixel Phase — Controls the pixel phase. Sampling at the optimum pixel phase results in a
bright, stable output.
In the
panel of the
Pixel Phase
arrows, or click and drag the slider to adjust the setting to the desired value. The field to the
right of a slider shows the current value for the associated setting.
NOTE: The value for Pixel Phase can range between 0 and 63. Default setting:
The total pixels setting (see below) must be correctly set before adjusting pixel phase.
Total Pixels — Controls the total number of pixels in an active window.
In the
panel of the
Shift
VGA Video Adjustment
or click and drag the slider to adjust the setting to the desired value. The field to the right of
a slider shows the current value for the associated setting.
NOTE: The Total Pixels setting depends on the input rate. It is ±255 of the default value.
Audio Adjustment panel
The
panel of the
Audio Adjustment
analog input audio.
Audio Gain and Attenuation — Adjusts the analog input audio gain or attenuation value.
This ranges from -18.0 dB to +10.0 dB in 1.0 dB increments.
In the
Audio Gain/Atten.
value is displayed in a field below the slider control.
Audio Output Level — Is not available for the FOX T UWP 302.
FOX T UWP 302 Wallplate Transmitter • FOX Extenders Control Program
VGA Video Adjustment
panel, click the
tab adjusts the gain and attenuation of
Control
panel, click and drag the slider to the desired level. The current
panel, click the
or
Left
Right
.
32
or
arrows,
Left
Right
35
Advertisement
Table of Contents
