Installation And Operation; Mounting The Unit; Connections And Reset Button; Rear Panel Features - Extron electronics DTP T USW 223 User Manual

Installation and
Operation
This section describes the installation and the operation of the DTP T USW 233, including:
•
•
•

Mounting the Unit

Mounting instructions can be found in
optional hardware is listed on the Extron website (www.extron.com).
ATTENTION:

Connections and Reset Button

Rear Panel Features

POWER
1
12V
--A MAX AUDIO
RGB, Y, R-Y, B-Y
INPUTS
10 3 1
Figure 2.
a
b
Mounting the Unit
Connections and Reset Button
Operation
• Installation and service must be performed by authorized personnel only.
• Avoid ground potential differences between the switching transmitter and receiver
installation sites, which can lead to equipment damage or a missing or unstable
picture. If a potential difference cannot be avoided, remove the ground connection
between the units and locally power both units (see
on page 19). In this configuration, the DTP T USW 233 cannot extend analog audio
and the paired receiver requires its own dedicated power supply.
2 3
HDMI HDMI
2
DTP T USW 233 Rear Panel Features
RGB, Y, R-Y, B-Y input port (input 1) — Plug an analog (RGB
and component) video source into the switching transmitter via this
15-pin HD connector. See VGA connector wiring
connector pinout.
HDMI input port (input 2 and 3) — Plug HDMI digital video
sources into the switching transmitter via these HDMI connectors. These
connectors can also accept DVI video with appropriate adapters.
Mounting the Switcher
OVER DTP
SIG LINK
RS-232
DTP OUT Tx Rx G Tx
2 5 4
on page 6 to for
DTP T USW 233 • Installation and Operation
on page 18. Compatible
Disconnecting the Ground
REMOTE
IR CONTACT TALLY RS-232
Rx 1 2 3 G 1 2 3 + V Tx Rx G
6 7 8
RGB, Y, R-Y, B-Y
RESET
9
HDMI
3