Operation; Reset - Extron electronics FOX3 T 301 User Manual

Operation

After the transmitter, receiver, and the connected devices are powered up, the system is fully
operational. If any problems are encountered, ensure all cables are routed and connected
properly.
NOTE: Ensure that the video source and display are properly connected to the FOX3
Configuration and operation of the system is accomplished via
Control
Software

Reset

The rear panel Reset button initiates three levels of resets (numbered 1, 4, and 5) that
are initiated from the rear panel reset button. Use a pointed stylus, ballpoint pen, or small
screwdriver to access the recessed button.
See the
ATTENTION:
Perform resets of the unit as follows (see figure 12):
Figure 12.
pair, and power is applied FOX3 pair and the display before power is applied to the
video source. If the other devices are not turned on before the video source, the image
may not appear.
(see page 23), the Internal Web Page
(see page 33).
Reset Modes
table on page 19 and figure 12 for a summary of the resets.
• Review the reset modes carefully. Some reset modes delete all user loaded content
and revert the device to default configuration.
• Analysez minutieusement les différents modes de réinitialisation. Certains modes de
réinitialisation suppriment l'intégralité du contenu chargé de l'utilisateur et remettent
l'appareil au mode de configuration par défaut.
Mode 1
RESET
Press and hold
the Reset button.
Mode 4
Reset LED flashes twice.
RESET
Press and hold
for 6 seconds.
Mode 5
Reset LED flashes three
times.
RESET
Press and hold
for 9 seconds.
Resets
FOX3 T/R 301/311 Transmitters and Receivers • Installation and Operation
(see page 42), and
RESET
Apply power
Release Reset button.
to the FOX3.
Release, then immediately
press and release again.
Reset LED flashes, then goes off.
RESET RESET
Release, then immediately
press and release again.
Reset LED flashes, then goes off.
RESET RESET
SIS Configuration and
Configuration
18