A
Fiber connector — For one-way video, audio, and serial communication from the
FOX T UWP 302 to a receiver, connect a fiber optic cable between the Tx port on the
FOX T UWP 302 and the Rx port on a compatible receiver.
To return serial data from a receiver to the FOX T UWP 302 (such as responses from a
controlled device) or for HDCP-compliance, connect a fiber optic cable between the Rx
port on the transmitter and the Tx port on the receiver.
Potential risk of severe injury. The
WARNING:
FOX T UWP 302 outputs continuous invisible light, which may
be harmful to the eyes; use with caution.
AVERTISSEMENT: Risque potentiel de blessure grave ou
de mort. Le FOX T UWP 302 émet une lumière invisible en
continu qui peut être dangereux pour les yeux, à utiliser avec
précaution.
•
Do not look into the rear panel iber optic cable connectors
or into the iber optic cables themselves.
•
Ne regardez pas dans les connecteurs de câble ibre
optique sur le panneau arrière ou dans les câbles ibre
optique eux-mêmes.
•
Plug the attached dust caps into the optical transceivers
when the iber cable is unplugged.
•
Branchez les protections contre la poussière dans
l'ensemble émetteur/récepteur lorsque le câble ibre optique
est débranché.
NOTES:
•
Ensure that you use the proper iber optic cable. Typically, singlemode iber
optic cable has a yellow jacket and multimode iber optic cable has an orange
or aqua jacket.
•
Only one iber optic cable, transmitter-Tx-to-receiver-Rx, is required for video,
audio, and serial command transmission, but the HDMI signal output on the
receiver will not be HDCP-compliant and the FOX T UWP 302 will not receive
RS-232 reports from the controlled device.
B
Remote RS-232 port — For serial RS-232 control, connect a host device
to the transmitter via the leftmost poles (Tx, Rx, and G) of this 5-pole
captive screw connector (see
Communication
on page 11 for wiring configuration).
Alarm output port — For remote monitoring of the status of fiber optic
link 2, connect a custom or furnished monitoring device to the transmitter
via the rightmost poles (1 and 2) of this 5-pole captive screw connector (see
Wiring for Remote RS-232 and Alarm Communication
NOTE: Pins 1 and 2 short when link 2 does not detect any connection.
C
Power connector — Connect the provided external 12 VDC power supply
to this 3.5 mm, 2-pole captive screw connector (see
Supply
on page 12).
FOX T UWP 302 Wallplate Transmitter • Installation and Operation
Wiring for Remote RS-232 and Alarm
Wiring the Power
Tx
Rx
OPTICAL
Transmitter
to
Receiver
Tx
Rx
OPTICAL
Tx Rx G
1
Tx Rx
G
1
on page 11).
7
2
2