Rear View - Lenovo System x3650 M5 Installation And Service Manual

Hide thumbs Also See for System x3650 M5:

Table of Contents

– IP v4 information

– IP v6 address

• System environmental information:

– Ambient temperature

– CPU temperature

– AC input voltage

– Estimated power consumption

Rear view

The following illustration shows the connectors on the rear of the server.

System-management

/ Ethernet (dedicated)

Figure 22. Rear view

System-management

/ Ethernet (dedicated)

Figure 23. Rear view: for machine type 8871-AC3

• NMI button: Press this button to force a nonmaskable interrupt to the microprocessor. It allows you to

blue screen the server and take a memory dump (use this button only when directed by the service

support). You might have to use a pen or the end of a straightened paper clip to press the button. The

NMI button is in the lower left-hand corner on the rear of the server.

• Power connector: Connect the power cord to this connector.

Note: Power supply 1 is the default/primary power supply. If power supply 1 fails, you must replace it

immediately.

• Video connector: Connect a monitor to this connector. The video connectors on the front and rear of

the server can be used simultaneously.

Note: The maximum video resolution is 1600 x 1200 at 75 Hz.

• USB connectors : Connect a USB device, such as a USB mouse or keyboard to any of these connectors.

For machine type 8871-AC3, two USB 3.0 and two USB 2.0 connectors are provided. For other models,

two USB 3.0 connectors are provided.

• Systems-management Ethernet connector: Use this connector to connect the server to a network for

full systems-management information control. This connector is used only by the IMM2.1. A dedicated

Lenovo System x3650 M5 Installation and Service Guide

Power supply 2

Power supply 1

Power supply 2

Power supply 1