Lenovo System x3650 M5 Installation And Service Manual page 201

Step 4. Reinstall any adapters and reconnect any internal cables you might have removed in other
procedures (see "Replacing an adapter" on page 196 and "Internal cable routing and connectors"
on page 135).
Step 5. Align the riser-card assembly with the selected PCI connector on the system board and align it with
the slots on the chassis; then, lower it into the server and press down firmly until the riser-card
assembly is seated correctly in the connector on the system board.
• For half-length and low profile adapters
Figure 120. Riser-card assembly installation - half-length and low profile adapters
• For full-height, full-length adapters
Note: Shipping brackets are only included in the server that is pre-configured with full-height,
full-length adapters
PCI riser-card
assembly 2
.
Chapter 5 Installing, removing, and replacing components
PCI riser-card
assembly 1
189