Lenovo System x3650 M5 Installation And Service Manual page 333

Signal cable
Figure 293. Cable connections
Step 8. Touch the static-protective package that contains the NVMe adapter to any unpainted metal
surface on the server. Then, remove the NVMe adapter from the package.
Step 9. Remove the PCI riser-card assemblies. (see "Removing a riser-card assembly" on page 186).
Step 10. Install NVMe adapters into the PCI connectors on the PCI riser card or the system board (see
"Replacing an adapter" on page 196).
Attention: Incomplete insertion might cause damage to the server or the adapter.
Step 11. Connect the four signal cables to the connectors on the NVMe adapter:
Figure 294. NVMe adapter connectors
Step 12. Align and install the PCI riser-card assemblies in the server (see "Replacing a riser-card assembly"
on page 188).
Step 13. Route the cables underneath the cable retention.
• 8x 2.5-inch HDD + 4x 2.5-inch NVMe PCIe SSD
2.5-inch NVMe backplane
Power / configuration cable
2.5-inch HDD hot-swap backplane
SAS signal cable
SAS signal cable
Port 1 Port 0
NVMe adapter
Power / configuration cable
2.5-inch HDD hot-swap backplane
Power / configuration cable
.
Chapter 5 Installing, removing, and replacing components
321