Lenovo System x3650 M5 Installation And Service Manual page 308

Hide thumbs Also See for System x3650 M5:

Table of Contents

Thumb screws

Figure 269. System board installation

Reconnect to the system board the cables that you disconnected in step 13 of "Removing the

system board" on page 292 (see "Internal cable routing and connectors" on page 135).

(Trained technician only) Install the microprocessor and heat sink (see "Replacing a microprocessor

and heat sink" on page 281).

Install the memory modules (see "Installing a memory module" on page 171).

If necessary, install the virtual media key.

Install the coin-cell battery (see "Replacing the coin-cell battery (also called CMOS battery)" on

Step 10. Install the PCI riser-card assemblies and adapters, if any were installed (see "Replacing an adapter"

on page 196 and "Replacing a riser-card assembly" on page 188).

Step 11. Install the air baffle (see "Replacing the air baffle" on page 153).

Step 12. Install the fan cage assembly (see "Replacing the fan cage assembly" on page 179).

Step 13. Install the top cover (see "Replacing the top cover" on page 151).

Step 14. Push the power supplies back into the server.

Step 15. Slide the server into the rack.

Step 16. Reconnect the power cords and any cables that you removed.

Step 17. Turn on the peripheral devices and the server.

Step 18. Start the Setup Utility and reset the configuration.

• Set the system date and time.

• Set the power-on password.

• Reconfigure the server.

See "Using the Setup Utility" on page 52 for more details.

Step 19. Either update the server with the latest RAID firmware or restore the pre-existing firmware from a

diskette or CD image.

Step 20. Update the UUID (see "Updating the Universal Unique Identifier (UUID)" on page 63).

Step 21. Update the DMI/SMBIOS (see "Updating the DMI/SMBIOS data" on page 65).

Lenovo System x3650 M5 Installation and Service Guide

System board handles

Troubleshooting