Lenovo System x3650 M5 Installation And Service Manual page 212

Expansion-slot cover
Figure 134. Adapter installation
Step 8. Rotate the retention latch to the close position.
Note: Fasten the screw on the retention latch to secure the adapter.
Step 9. If you are installing a full-height, full-length adapter, insert the shipping brackets.
PCI riser assembly
Figure 135. Full-height, full-length adapter
Step 10. Connect any required cables to the adapter.
Attention:
• When you route cables, do not block any connectors or the ventilated space around any of
the fans.
• Make sure that cables are not routed on top of components that are under the riser-card
assembly.
• Make sure that cables are not pinched by the server components.
Step 11. Align the riser-card assembly with the selected PCI connector on the system board and align it with
the slots on the chassis; then, lower it into the server and press down firmly until the riser-card
assembly is seated correctly in the connector on the system board.
• For half-length and low profile adapters
200
Lenovo System x3650 M5 Installation and Service Guide
Bracket
1
2
3
Adapter
Shipping bracket
PCI riser-card assembly
Adapter connector