Preparation For Washing And Rinsing; Automatic Dosing - Meiko EcoStar 430 F-MIKE Operating Instructions Manual

Operating instructions EcoStar 430 F-M
CAUTION!
Datei:1_EcoStar430F-MIKE_9702129_Betriebsanleitung_EN_2012-07.docx
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
Key / display
Table 1; Program key function / items to be washed
8.2

Preparation for washing and rinsing

The preparatory work described below must be carried out before each opera-
tion.
Open the door.
Place the screen and stand pipe in position.
Close the door.
Caution! Danger of crushing.
Close the door with both hands.
Switch on the appliance by pressing one of the program pre-selection keys.
During the filling and heating phase, the light above the pre-selection key will flash.
When the light remains constantly lit, the machine is ready for operation.
The time until the operation readiness is reached depends on the temperature of the
supplied water and the installed boiler, resp. tank heating capacity.
In the case of cold water supply, the time taken is: about 20 minutes.
8.3

Automatic dosing

The required detergent and rinse aid is moved from the containers into the tank or boiler
via electronically controlled dosing units.
If unsuitable products are used, the life of the dosing equipment will be significantly
shortened.
We therefore recommend that detergents should have a pH value greater than 7 and
that rinse agents should have a pH value between 7 and 2.
Update:
W e reserv e the right to change execution and construction!
Meaning
Short program – Wash programme I
Normal program – Wash program II
Wash temperature
Final rinse temperature
Program start
Tank drain
Self-cleaning cycle
Switch off appliance /
Cycle interruption
9702129 15/38