Introduction
1.4 Software interface
Screen item
③
④
⑤
1.4.2
Protection levels
Protection levels
SINUMERIK 808D provides a concept of protection levels for enabling data areas. Different
protection levels control different access rights.
The control system delivered from SIEMENS is set by default to the lowest protection level 7
(without password). If the password is no longer known, the control system must be
reinitialized with the default machine data. All passwords are then reset to default passwords
for this software release.
NOTICE
Before you boot the control system with default machine data, make sure that you have
backed up your data; otherwise, all data is lost after rebooting with the default machine
data.
Protection level
0
1
2
3-6
7
20
Display
Description
HMI status information
Lowercase letter input active
RS232 connection active
Connection to PLC Programming Tool
Horizontal softkey bar
Vertical softkey bar
Locked by
Siemens password
Manufacturer password
Reserved
End-user password
(Default password: "CUSTOMER")
No password
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
Area
Siemens, reserved
Machine manufacturers
End users
End users
Milling
Part 1: Operation