...
Circular workpiece measurement
...
Milling
Part 1: Operation
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
5.
Traverse the tool, which has been measured previously, in the
direction of the orange arrow P1 shown in the measuring window, in
order to scratch the workpiece edge with the tool tip.
6.
Press this vertical softkey to save the tool position P1 in the
coordinate system.
7.
Repeat Steps 5 and 6 to save the other three positions: P2, P3 and
P4.
8.
Press this vertical softkey to save the work offsets in the X and Y
axes after all four positions are measured.
1.
Select the desired operating area.
2.
Switch to "JOG" mode.
3.
Open the lower-level menu for workpiece measurement.
4.
Press this vertical softkey to open the window for measurement of a
circular workpiece.
5.
Traverse the tool, which has been measured previously, in the
direction of the orange arrow P1 shown in the measuring window, in
order to scratch the workpiece edge with the tool tip.
6.
Press this vertical softkey to save the tool position P1 in the
coordinate system.
7.
Repeat Steps 5 and 6 to save the other two positions: P2 and P3.
8.
Press this vertical softkey to save the work offsets in the X and Y
axes after all three positions are measured.
Setting-up
3.2 Setting up the workpiece
43