Siemens SINUMERIK 808D Milling Programming And Operating Manual page 56

Part programming
4.2 Editing part programs
Searching for strings
Proceed through the following steps to search for strings:
Copying and pasting blocks
Proceed through the following steps to copy and paste blocks:
Editing part programs in "MDA" mode in the machining area
In "MDA" mode, you can create new programs or load existing programs from directories on
the control system.
Proceed through the following steps to edit part programs:
56
1. Press this softkey in the opened program editor window.
2. Press this softkey to search via text. Alternatively, you can search with a
given line number by pressing the following softkey:
2. Enter the search text or line number in the input field, and press this key
to select a starting point for search.
4. Press this softkey to start the search, or otherwise, press the following
softkey to cancel the search:
1. Press this softkey in the opened program editor window to insert a
marker.
2 Use the cursor keys to select the desired program blocks.
3. Press this softkey to copy the selection to the buffer memory.
4. Place the cursor on the desired insertion point in the program and press
this softkey.
The data is successfully pasted.
1. Select the desired operating area.
2. Switch to "MDA" mode.
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
Milling Part 1: Operation