Softkeys in Window "①"
Softkeys in Window "②"
Softkeys in Window "③"
Milling
Part 1: Operation
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
Use this softkey to select cross references
A cross reference is marked by the characters "≫ ... ≪".
Note:
This softkey is displayed only if the current page contains a cross reference.
Searches for a term in the current topic
Continues search for the next term that matches the search criteria
Exits the help system
Zooms in the current view
Zooms out the current view
Zooms the current view to page width
Jumps to the desired page
Searches for a term in the current topic
Continues search for the next term that matches the search criteria
Exits the help system
Expands hierarchical topics
Collapses hierarchical topics
Introduction
1.4 Software interface
23