Siemens SINUMERIK 808D Milling Programming And Operating Manual page 84

Part programming
4.5 Free contour programming
Example 3
Starting point: X=0 abs., Y=5.7 abs., machining plane G17
The contour is programmed in a clockwise direction.
Figure 4-7
Operating sequence:
84
Workshop drawing of the contour, example 3
1. Select the desired operating area.
2. Enter the desired program folder.
3. Select a program with cursor keys and press this key to open the program
in the program editor.
4. Press this softkey to open the contour editor.
5. Define a start point with the following parameters and press this softkey to
confirm.
 Programming plane: G17
 X: 0 abs.
 Y: 5.7 abs.
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
Milling Part 1: Operation