Example 2
Starting point: X=0 abs., Y=0 abs., machining plane G17
The contour is programmed in the clockwise direction with dialog selection.
Figure 4-6
Operating sequence:
Milling
Part 1: Operation
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
Workshop drawing of the contour, example 2
1.
Select the desired operating area.
2.
Enter the desired program folder.
3.
Select a program with cursor keys and press this key to open the program
in the program editor.
4.
Press this softkey to open the contour editor.
5.
Define a start point with the following parameters and press this softkey to
confirm.
Programming plane: G17
X: 0
Y: 0
Part programming
4.5 Free contour programming
81