Siemens SINUMERIK 808D Milling Programming And Operating Manual page 85

Milling Part 1: Operation
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
6. Press this softkey to select a contour element of circular arc.
7. Enter the parameters for this element and press this softkey to select the
desired contour characteristics.
 Direction of rotation: counter-clockwise
 R: 9.5
 I: 0 abs.
 RND: 2
8. Press this softkey to confirm.
9. Press this softkey to select a contour element of straight line in any
direction.
10. Enter the parameters for this element and press this softkey to confirm.
 α1: -30 °
11. Press this softkey to select a contour element of circular arc.
12. Enter the parameters for this element and press this softkey to select the
desired contour characteristics.
 Direction of rotation: clockwise
 R: 2
 J: 4.65 abs.
13. Press this softkey to confirm.
14. Press this softkey to select a contour element of circular arc.
15. Enter the parameters for this element and press this softkey to select the
desired contour characteristics.
 Direction of rotation: counter-clockwise
 R: 3.2
 I: 11.5 abs.
 J: 0 abs.
16. Press this softkey to confirm.
17. Press this softkey to select a contour element of circular arc.
18. Enter the parameters for this element and press this softkey to select the
desired contour characteristics.
 Direction of rotation: clockwise
 R: 2
 J: -4.65 abs.
Part programming
4.5 Free contour programming
85