Other Settings In "Jog" Mode - Siemens SINUMERIK 808D Milling Programming And Operating Manual

Setting-up

3.5 Other settings in "JOG" mode

3.5 Other settings in "JOG" mode
Softkey functions
Pressing
following window:
①
Opens the "T, S, M" window where you can activate
tools, set spindle speed and direction, and select a G
code or other M function for activating the settable work
offset.
②
Switches the display to the relative coordinate system.
You can set the reference point in this coordinate
system.
③
Opens the workpiece measurement window where you
determine the work offset data. For detailed information
about this window, refer to Section "Measuring the
workpiece (Page 41)".
④
Opens the tool measurement window where you
determine the tool offset data. For detailed information
about this window, refer to Sections "Measuring the tool
(manually) (Page 33)", "Measuring the tool with a probe
(auto) (Page 36)" and "Calibrating the tool probe
(Page 38)".
⑤
Opens the face cutting window where you specify
parameters for machining the end face or peripheral
surface of a blank without creating a special part
program. For detailed information about this window,
refer to Section "Face milling (Page 50)".
48
key on the PPU and then
⑥
⑦
⑧
⑨
⑩
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
key on the MCP allows you to open the
Opens the settings window where you can set JOG
feedrate and variable increment values.
Displays the axis feedrate in the selected coordinate
system.
Displays the axis position data in the relative coordinate
system.
Displays the axis position data in the workpiece
coordinate system.
Displays the axis position data in the machine
coordinate system.
Milling Part 1: Operation