Siemens SINUMERIK 808D Milling Programming And Operating Manual page 12

Introduction
1.2 Machine control panels
Pre-defined insertion strips
The MCP (machine control panel) package includes two sets (six pieces each) of pre-
defined insertion strips. One set is for the turning version of the control system and is pre-
inserted in the back of the MCP. The other set is for the milling version of the control system.
For a milling version of the control system, replace the pre-inserted strips with the milling-
specific insertion strips.
①
②
Customized insertion strips
The MCP package also includes an A4-sized blank plastic sheet with detachable strips. You
can customize insertion strips if the pre-defined strips can not meet your needs.
In the \04040000\examples\MCP folder of the Toolbox DVD for the SINUMERIK 808D, there
is a symbol library file and an insertion strip template file. To make customized insertion
strips, follow the steps below:
1. Copy the desired symbols from the symbol library file to the desired locations in the
2. Print the template to the A4-sized blank plastic sheet.
12
Insertion strips for turning version of the control system
Insertion strips for milling version of the control system
insertion strip template.
Resets NC programs

Cancels alarms that meet the cancel criterion

Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
Milling Part 1: Operation