Siemens SINUMERIK 808D Milling Programming And Operating Manual page 45

Min. (G25) fields can only be performed within the
④
limit values defined in the machine data.
Setting the time counter
Operating sequence
Parameters in the time counter window
1
2
3
4
5
6
7
8
①
The total number of workpieces produced (total
actual)
Milling Part 1: Operation
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
1. Select the desired operating area.
2. Open the setting data window.
3. Open the time counter window.
4. Position the cursor bar in the input fields to be modified and enter the
values (see table below for the parameter descriptions).
5. Use this key or move the cursor to confirm your entries.
⑤
3.3 Entering / modifying the setting data
displayed as the start angle. A multiple thread can be cut
by changing the angle when the thread cutting operation
is repeated.
The run time of the selected NC program in seconds
The default value is 0 each time a new NC program
starts up. MD27860 can be set to ensure that this value
will be deleted even if there is a jump to the beginning of
the program with GOTOS or in the event of ASUBS
(used for tool change in "JOG" and "MM+" modes) and
PROG_EVENTs starting.
Setting-up
45