Siemens SINUMERIK 808D Milling Programming And Operating Manual page 95

Reading in a part program from external
Note
The program files can be transferred only to the system drive N:\MPF or N:\CMA; therefore,
before transfer, make sure the drive identifier contained in the first line in the program file is
"N" and the target directory in the second line is "N_MPF" or "N_CMA". If not, you must
change manually, for example:
Proceed as follows to transfer a part program:
Milling Part 1: Operation
Programming and Operating Manual, 12/2012, 6FC5398-4DP10-0BA0
1. Select the desired operating area on the PPU.
2. Press this softkey to go to the RS232 directory.
3. Press this vertical softkey in the RS232 window.
4. Press this button on the main screen of SinuComPCIN and select the
desired program for execution, for example, Test.mpf. The data
transferring starts.
On the NC side:
On the SinuComPCIN side:
5. Wait until SinuComPCIN has finished data transfer, and click this button.
5.5 Executing / reading in a part program from external
Automatic machining
95