Installing The Saddle Finisher/Switchback Unit (Option) - Kyocera KM-2530 Service Manual

1-3-8 Installing the saddle finisher/switchback unit (option)

Preparation
1. Open the conveying cover of the copier.
2. Remove the two screws securing the
feedshift guide assembly and then the
assembly.
3. Fit the curl eliminator to the conveying cover
such that the projections on the cover fit into
the two ends of the curl eliminator.
4. Secure the curl eliminator using the two
screws removed in step 2.
5. Close the conveying cover.
6. Fit the latch catch to the conveying cover
using two M4 × 10 binding screws.
Screws
Feedshift guide
assembly
Figure 1-3-37
Projection
Screw
Curl eliminator
Figure 1-3-38
Conveying cover
Latch catch
M4 × 10 binding screws
Figure 1-3-39
2DF
Conveying
cover
Screw
Projection
1-3-25