Kyocera KM-2530 Service Manual page 217

2DF
• Removing the paper feed pulley
6. Remove the two stop rings.
7. Pull the paper feed shaft toward the rear of
the primary paper feed unit (in the direction of
the arrow) and remove the paper feed pulley.
• Removing the separation pulley
8. Remove the stop ring on the rear of the
primary paper feed unit.
9. Pull the separation shaft toward the machine
rear (in the direction of the arrow) and
remove the separation pulley.
10. Replace the forwarding, paper feed and
separation pulleys.
Caution:
• When fitting the forwarding pulley, orient it
correctly as shown in Figure 1-6-6.
• When fitting the separation pulley, keep the blue
end of the separation toward the machine rear.
11. Refit all removed parts.
1-6-4
Paper feed shaft
Paper feed pulley
Figure 1-6-4
Stop ring
Separation shaft
Separation pulley
Figure 1-6-5
Machine front
Forwarding pulley
Figure 1-6-6
Stop rings
Machine rear