Kyocera KM-2530 Service Manual page 53

6. Adjust the height of the left two casters in the
same manner as in step 4 so that the top and
bottom gaps (A) between the finisher and the
copier are the same when the finisher is
detached from the copier.
7. Retighten the two screws on each of the four
casters.
8. Refit the two covers and four caps.
Connecting the signal cable
1. Connect the signal cable of the finisher to the
copier. If the switchback unit has been
installed, connect the signal cable of the
switchback unit, as well.
2. Insert the copier power plug to the wall outlet
and turn the main switch on.
3. Make test copeies and check that the finisher
and the switchback unit operate correctly.
A
A
Figure 1-3-60
Signal cable of
the finisher
Signal cable of
the switchback unit
Figure 1-3-61
2DF
1-3-33