Kyocera KM-2530 Service Manual page 52

2DF
3. Loosen the two screws on each of the four
casters.
4. Adjust the height of the rear right caster by
turning its adjustment bolt using a cross-
headed screwdriver so that the axis of the pin
of the latch catch is aligned with the middle of
the three markings on the right of the slot of
the finisher or switchback unit when the
finisher is joined to the copier (viewed from
the machine front).
Note: Turning the adjustment bolts clockwise
lowers the finisher, while turning them
counterclockwise lifts the finisher.
Screws
5. Adjust the height of the front right caster in
the same manner as in step 4 so that the axis
of the pin of the latch catch is aligned with the
marking above the slot and the center of the
two hooks on the finisher align with the center
of the holes on the latch catch when the
finisher is joined to the copier (viewed from
above).
Slot
1-3-32
Adjustment bolt
Hooks
Pin
Slot
Caster
Pin
Holes
Pin
Figure 1-3-58
Figure 1-3-59
Pin