Kyocera KM-2530 Service Manual page 68

2DF
4. Insert the RTC board at an angle into the
RTC board slot on the main PCB.
5. Push the free end of the RTC board down
toward the fax board.
6. Remove 2 screws, and take off the cover.
7. Firmly push connector CN1 on the scanner
board all the way into connector CN50 on the
main PCB.
8. Fasten the scanner board with 2 screws.
1-3-46
Main PCB
Screws
Scanner board
Screws
RTC board
Figure 1-3-96
Cover
Figure 1-3-97
Connector CN50
Connector CN1
Figure 1-3-98
RTC board slot