Kyocera KM-2530 Service Manual page 74

2DF
8. Remove the blue screw from the transfer unit
and then remove the mounting plate.
9. Remove the securing tape from the 13-pin
connector, pass the wire under the stapler
motor, and connect the wire with the 13-pin
connector.
10. Insert the transfer unit into the copier from the
front side and slide it to the left.
Secure the unit using two +TP-A bronze
screws M3 × 05 and the pin that has been
fitted to the transfer unit.
Transfer unit
11. Insert the metal hook of the transfer unit into
the oblong hole of the frame of the copier and
secure it using a +TP-A bronze screw M3 ×
05.
* Insert the projection of the frame into the
hole of the metal hook to position the hook.
* Arrange the cable to position it under the
metal fittings.
1-3-52
Transfer unit
Mounting plate
Blue screw
Securing tape
+TP-A bronze screw M3 × 05
+TP-A bronze screw M3 × 05
Figure 1-3-111
Metal fittings
13-pin
connector
Figure 1-3-110-2
Pin
Hook
Oblong hole
+TP-A bronze
screw M3 × 05
Hole
Cable
Figure 1-3-112
Projection