Kyocera KM-2530 Service Manual page 201

2DF
(12) The leading edge of
the image is sporadi-
cally misaligned with
the original.
Causes
1. Feed clutch, paper feed clutch, bypass paper
feed clutch or registration clutch installed or
operating incorrectly.
(13) Paper creases.
Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
4. Defective separation.
5. Defective fans.
(14) Offset occurs.
Causes
1. Defective cleaning blade.
2. Defective fixing section.
1-5-48
Causes
1. Feed clutch, paper feed clutch, bypass paper
feed clutch or registration clutch installed or
operating incorrectly.
Check the installation position and operation of the feed clutch,
paper feed clutch, bypass paper feed clutch and registration clutch. If
any of them operates incorrectly, replace it.
Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
4. Defective separation.
5. Defective fans.
Check the paper storage conditions.
Check the paper storage conditions.
Replace the pressure springs.
Check the drum separation claws and heat roller separation claws.
Replace the fans.
Causes
1. Defective cleaning blade.
2. Defective fixing section.
Replace the cleaning blade (see page 1-6-46).
Replace the heat roller and press roller.
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures