Programmed Operation; Precool/Heat Temperature Screen - Beckman Coulter Optima L-XP Instructions For Use Manual

7
To cancel Delay Start, press the
8
(
Press
(
Press
Figure 2.12 Precool/Heat Temperature Screen
NOTE
To save the run parameters for future recall, press
dialog box.
9
When all required parameters are entered, press
run at any time by pressing
NOTE
Run parameters may be printed out for record keeping purposes. See
Requirements, for printer hookup instructions.
If you downloaded the run from a previously established program, the program name and the rotor
in use (if a rotor was selected) will be displayed below the parameter entry positions.

Programmed Operation

Program options are accessed through the Setup menu as shown in
and recall programs containing protocols that you plan to re-use. Each saved program is stored in
a separate file for easy run duplication. Several of the program setup windows can also be used to
determine parameters through calculations or conversions. Most program setup windows have an
upper portion where calculations and conversions are done, and a lower portion where you can
enter additional run parameters if you want to download or save the program.
PN LXP-IM-7AB
)
, then enter chamber precool or preheat temperature (see
Precool/Heat
)
to begin temperature control.
Start Temp
(
Stop
( )
button on the control panel.
Stop
(
Save
( )
Enter
)
on the keypad.
Programmed Operation
Figure
)
, then enter a program name in the
( )
, then . You can terminate a
Start
APPENDIX A, Preinstallation
Figure 2.13. You can enter, save,
2
Operation
2.12).
2-15